Tamko Gutter Replacement Nationwide

Tamko Gutter Replacement: The Miami Owner’s Guide

Tamko gutter replacement in Miami typically runs $12 to $22 per linear foot installed, which puts a standard single-story home with roughly 160 linear feet of gutter between $1,900 and $3,500 total. We stock Tamko-compatible aluminum and steel gutter profiles on our trucks, so most replacements are done same-day once we’ve measured your roofline. Most Miami homeowners discover their Tamko gutters have failed the hard way: after a heavy afternoon storm, water sheets off the roofline instead of channeling through the downspouts, or a corner starts pulling away and dripping onto the walkway below.

Call (850) 613-1762

Here’s the reality Greg Holloway sees on inspection calls across Miami: Tamko gutters fail gradually in this climate, and by the time you notice the sag or the rust stain, the damage has usually been working for months. Salt air near Coconut Grove and Coral Gables accelerates corrosion on steel profiles, while aluminum systems hold up better but still suffer at the seams. Knowing what to look for before the next hurricane season saves you from ceiling stains and fascia rot that cost far more than the gutter itself.

Key Takeaways

• Cost: $12 – $22 per linear foot installed in Miami, depending on profile and material
• Speed: Most Tamko-compatible gutter replacement done same-day, with a written price before work starts
• OEM vs aftermarket: Tamko-branded gutter components are available, but quality-matched aluminum equivalents perform identically in Miami’s climate at 20 – 30% less
• Coverage: Every repair carries our written guarantee, backed by the 365-Day Done Right Promise

Which Tamko Models This Applies To

Tamko manufacturers gutter components under several product lines, including the Heritage, MetalWorks, and Tuff-Seal series. The bad news for Miami homeowners: gutters are rarely the thing Tamko stamps with a big serial number you can read from the ground. The good news: identifying what you have is simpler than you might think, and we do it on every inspection visit.

Most Tamko residential gutter systems are either 5-inch K-style aluminum (the profile that looks like crown molding from the ground) or 6-inch half-round steel on older homes. The K-style profile is the workhorse here in Miami because it carries more water volume per inch than half-round, which matters when a summer squall dumps three inches of rain in an hour. If you can reach your gutter safely, look underneath the lip for a stamped gauge number: .027″ and .032″ aluminum are the two most common Tamko-compatible thicknesses we replace. Thicker .032″ costs roughly $2 more per linear foot and lasts meaningfully longer in coastal air.

One Miami-specific compatibility note: Tamko’s MetalWorks steel gutters, common on homes built in the 1990s around Kendall and Westchester, carry a baked-on finish that fails in patches once scratches expose the steel. You can replace with an OEM Tamko steel profile if you want a direct match, but we often recommend a .032″ aluminum equivalent instead. It won’t rust at the scratch points, and the color range (we stock white, bronze, and matte black on the truck, with custom Tamko colors orderable in 3 – 5 days) makes the switch invisible from the curb.

We’re an independent Miami roofing contractor, not a Tamko affiliate, which means we’re free to tell you when an equivalent product does the same job for less money. We also work with GAF, Owens Corning, and CertainTeed components when the home calls for a different manufacturer match.

Signs Your Tamko Gutter Replacement Is Failing

• Water pouring over the front lip during normal rain. This usually means the hangers have loosened and the gutter has pitched backwards, so water pools instead of flowing to the downspout. In Miami, the expansion and contraction of aluminum through our hot, wet summers works hangers loose faster than almost any other climate in the country.
• Sagging sections pulling away from the fascia board. The weight of standing water plus decomposing leaves (especially under live oaks in Coral Gables) stresses the gutter spikes and ferrules. Once a section sags more than half an inch, the whole run needs re-pitched or replaced, not just re-hung.
• Rust streaks or flaking coating on the outer face. Tamko steel gutters in South Florida show this first on the windward side of the house, where ocean salt and afternoon rain hit hardest. Streaking means the protective coating has failed and the metal underneath is oxidizing, which shortens the remaining life to a couple of years at most.
• Water staining on the fascia board or soffit behind the gutter. This tells us water is getting between the gutter and the house, which means the drip edge or the gutter’s back lip has failed to direct water properly. Fascia repair often becomes part of the replacement job once we open things up.
• Separated seams leaking at the corners or at mid-run joints. Even quality Tamko gutters eventually fail at sealed seams, especially in Miami’s humidity, which keeps sealants from ever fully curing in the summer months. Corner joints on south-facing runs get the worst of it: constant UV exposure dries and cracks the sealant years before the metal itself wears out.

Replacement Cost & What’s Included

Here’s the straight pricing for Tamko gutter replacement in Miami, using the numbers we quote on every estimate:

• 5-inch K-style aluminum (.027″): $12 – $15 per linear foot installed
• 5-inch K-style aluminum (.032″): $14 – $17 per linear foot installed
• 6-inch K-style or half-round steel: $16 – $22 per linear foot installed
• Downspout replacement (2″×3″ or 3″×4″): $8 – $14 per linear foot installed, depending on gauge and color
• Fascia repair or replacement (when rotted behind old gutter): $6 – $12 per linear foot, quoted after inspection

The range depends on three things: the linear footage of your roofline, the profile and thickness you choose, and whether we’re replacing downspouts and fascia in the same trip. Every quote from Tilehurst Roofing Miami is a written, line-item price you get before any work starts. No change orders at the door, no “we found more damage” upcharge after we start pulling old gutter off. If we do find hidden fascia rot, we show you, explain the cost, and wait for your go-ahead before touching it.

Every gutter replacement carries our written guarantee, delivered before the crew leaves, covering materials and labor for one year under the 365-Day Done Right Promise. If the gutter fails inside that year, we come back and correct it at no charge.

DIY or Call Us?

You can safely inspect your Tamko gutters from the ground with a pair of binoculars and a good angle, and you can clear leaves and debris from the gutter channel yourself if you’re comfortable on a ladder. Those two things will extend the life of any gutter system in Miami, and we’re the first to tell you that.

What we don’t recommend is attempting a full gutter replacement on a two-story home or any roofline over a slope. The injury risk from ladder work near the eave line is real, and Miami’s afternoon thunderstorms don’t give you a schedule. Getting the pitch right (a quarter inch of fall every ten feet, minimum) is harder than it looks, and a gutter that pitches the wrong direction actively damages your fascia and foundation by concentrating water where it shouldn’t be. If you’re on a single-story home with a walkable roofline and you’re genuinely confident on a ladder, we’ll even sell you the materials and tell you what to buy. But most Miami homeowners we talk to would rather have a crew that’s done a thousand of these, with a written price and a guarantee backing it. Call (850) 613-1762 and we’ll measure your roofline and hand you a quote.

FAQs